Omron ZG2 Series User Manual page 66

5
step
Setting the measurement area
Area for point 1 Area for point 2
Note
• If the target area is not displayed by automatic setting, select [CUSTOM], and adjust the
area for each individual measurement point.
• To narrow the area in the vertical direction, adjust by the sensitivity adjustment area.
p.99
ZG2 User's Manual
TRIMMING
↑↓ 50.000mm
←→ 123LINE SET
TRIMMING
↑↓ 10.000mm
←→ 450LINE SET
MEAS/2PTS-2
1ITEM 2CUSTOM
3SCALE
1
Adjust the top left of the desired
measurement area, and press the
SET key.
2
Adjust the bottom right of the
desired measurement area, and
press the SET key.
Important
Adjust the area so that the center line
overlaps the vicinity of the area of the
vertical line so as to enclose the two
steps to be measured.
Center line
When the desired measurement
area is enclosed, the region in which
measurement points are extracted is
automatically set.
Flow of Basic Setup
63