Error Messages And Corrective Actions - Omron ZG2 Series User Manual

Error Messages and Corrective Actions

The following shows error messages that are displayed on the LCD screen and their
corrective actions.
Error message
AUTO SETTING FAILED Automatic setting cannot be executed on the current
AUTO SCALING DO
NOT OPERATE AB.
THIS ITEM
REFERENCE
REGISTRATION FAILED
NO MEASUREMENT
POINT
SYSTEM ERROR VDIN
END ERR
SYSDATA ERROR
SCALING FAILED
SET VALUE ERROR
HIGH, LOW
SET VALUE ERROR
MAX, MIN
CLEAR BANK DATA
BANKDATA ERROR
ZG2 User's Manual
Probable cause
region.
Set the region again referring to the manual.
The auto-scaling function does not operate with cross-
sectional area and angle.
Failed to register the reference for position correction.
1. Check whether or not teaching of the profile has been
successful.
2. Check whether or not the edge level has been set
correctly.
There is no measurement target.
Place the measurement target inside the measurement
range.
Communication with the Sensor Head is not possible.
1. Check the cable connection with the Sensor Head.
2. Check the cable for breaks.
If there is no problem with the above, a probable cause is
a Sensor Head or Controller malfunction.
Loading of the system data failed.
1. Check the communication cable connection.
2. Check the communication settings.
3. Check to see if the correct file has been sent.
The scaling correction range was exceeded.
Check the input values.
Review the setting values so that HIGH>LOW.
Review the setting values so that MAX>MIN.
When the CCD mode is changed, all bank data is
initialized.
Loading of the bank data failed.
1. Check the communication cable connection.
2. Check to see if the correct file has been sent.
Error Messages and Corrective Actions
Reference
p.70
p.91
p.109
p.91
p.49
p.149
p.91
p.64
p.132
p.134
p.121
p.23
p.149
211