Carburetor Removal - General; Carburetor Disassembly - 50Cc (Mikuni) - Polaris PREDATOR 50 2009 Manual

FUEL SYSTEM

Carburetor Removal - General

The following procedure is provided to use as a reference when
removing the carburetor from either of the 4-stroke youth
models. Some steps may differ slightly between models.
1. Turn the fuel valve "OFF" and drain the fuel from the carb
through the drain screw (A).
2. Loosen or remove screw (B) retaining the choke cable and
disconnect the cable end from the choke arm.
3. Remove the carburetor mounting bolts (C).
4. Loosen the intake boot clamp (D) between the carburetor
and air cleaner.
D
5. Rotate the carb to allow access to remove the slide.
Slide Cap
6. Remove the fuel line and vent lines. Remove carburetor
from ATV.
4.10
B
C
A

Carburetor Disassembly - 50cc (Mikuni)

Use the following procedure to disassemble the Mikuni
carburetor used on the 50cc models.
1. Remove the (4) float bowl screws and float bowl (E).
E
2. Remove the float pin (F), float (G), and inlet needle (H).
F
G
3. Remove the screw (J) retaining the inlet seat and remove
the retaining bracket and seat (K) from the carburetor.
K
H
J