Battery; Battery Maintenance Service Notes; New Battery Activation - Polaris PREDATOR 50 2009 Manual

Table of Contents

Advertisement

ELECTRICAL

BATTERY

Battery Maintenance Service Notes

Battery electrolyte is poisonous. It contains
sulfuric acid. Serious burns can result from
contact with skin, eyes or clothing. Antidote:
External: Flush with water.
Internal: Drink large quantities of water or milk.
Follow with milk of magnesia, beaten egg, or
vegetable oil. Call physician immediately.
Eyes: Flush with water for 15 minutes and get
prompt medical attention.
Batteries produce explosive gases. Keep
sparks, flame, cigarettes, etc. away. Ventilate
when charging or using in an enclosed space.
Always shield eyes when
working near batteries.
KEEP OUT OF REACH OF CHILDREN.
CAUTION
Always wear safety glasses, rubber protective
gloves and appropriate clothing when
working with batteries.
IMPORTANT: DO NOT activate Youth ATV batteries
unless they will be put into service within 30 days of
activation.
Youth ATVs have a Low Maintenance style battery. Do not
remove the battery cap strip to check acid level or add water
once the battery have been activated. Perform the proper battery
tests and charge or replace the battery as required.
New batteries must be fully charged before use or battery life
will be significantly reduced (10-30% of the battery's full
potential).
NOTE: DO NOT use a constant high-amperage
battery charger to charge this style of battery. Use a
low-amperage charger capable of charging voltage
that is 1/10 of the battery amp-hour rating.
8.14
WARNING

New Battery Activation

Battery electrolyte is poisonous. It contains sul-
furic acid. Serious burns can result from contact
with skin, eyes or clothing. Antidote:
External: Flush with water.
Internal: Drink large quantities of water or milk.
Eyes: Flush with water for 15 minutes and get
prompt medical attention.
Batteries produce explosive gases. Keep
sparks, cigarettes, etc. away. Ventilate when
charging or using in an enclosed space. Always
shield eyes when working near batteries.
KEEP OUT OF REACH OF CHILDREN
To ensure maximum service life and performance from a new
battery, perform the following steps.
1.
Remove the battery (1), battery acid (2), funnel (3) and cap
(4) from the box.
1
4
2.
Remove the protective strip from the top of the battery.
Insert the battery electrolyte funnel into the filler holes.
3.
Carefully press the battery electrolyte pack onto the funnel.
The funnel will puncture the pack seals, releasing
electrolyte into the battery. Allow the pack to drain for 20
minutes, periodically tapping the sides to release any air-
lock or bubbles that may be present.
4.
Properly dispose of the battery electrolyte pack. Let battery
set with the vent cap strip off for 30 minutes to allow full
absorption of the electrolyte. After 30 minutes, install the
battery seal strip onto the battery.
5.
Charge the battery initially for 3 to 5 hours using Christie
Charger PA-37453 or a charger with an output capable of
1/10th the battery's amp-hour rating.
WARNING
2
3

Advertisement

Table of Contents
loading

Table of Contents