Handlebar; Predator 50 Exploded View; Outlaw 90 Exploded View; Sportsman 90 Exploded View - Polaris PREDATOR 50 2009 Manual

BODY / SUSPENSION / STEERING

HANDLEBAR

Predator 50 Exploded View

1. Install the lower clamps. (circle)
25 ft. lbs.
(34 Nm)
2. Proceed to "Brake Lever Adjustments".

Outlaw 90 Exploded View

25 ft. lbs.
(34 Nm)

Sportsman 90 Exploded View

25 ft. lbs.
(34 Nm)
5.20
42 in. lbs.
(4.7 Nm)
84 in. lbs.
(10 Nm)
42 in. lbs.
(4.7 Nm)
84 in. lbs.
(10 Nm)
42 in. lbs.
(4.7 Nm)
84 in. lbs.
(10 Nm)
42 in. lbs.
(4.7 Nm)

DECAL REPLACEMENT

The following procedure involves the use of an
open flame. Perform this procedure in a well
ventilated area, away from gasoline or other
flammable materials. Be sure the area to be
flame treated is clean and free of gasoline
or flammable residue.
Do not flame treat components that are installed
on the vehicle. Remove the component from the
vehicle before flame treating.
The side panels, front and rear fender cabs are plastic
polyethylene material. Therefore, they must be "flame treated"
prior to installing a decal to ensure good adhesion. A bonus of
the flame treating procedure is it can be used to reduce or
eliminate the whitish stress marks that are sometimes left after
a fender or cab is bent, flexed, or damaged.
To flame treat the decal area:
1. Pass the flame of a propane torch back and forth quickly
over the area where the decal is to be applied until the
surface appears slightly glossy. This should occur after just
a few seconds of flame treating. Do not hold the torch too
close to the surface (2-3 inches from the flame tip is
recommended). Keep the torch moving to prevent damage.
2. Apply the decal on one edge first. Slowly lay down
remainder of the decal while rubbing lightly over the decal
surface to eliminate any air bubbles during the application.
WARNING
WARNING