Tail Light; Tail Light Lamp Replacement; Indicator Lamps (90Cc Models); Indicator Lamp Replacement - Polaris PREDATOR 50 2009 Manual

ELECTRICAL

TAIL LIGHT

Tail Light Lamp Replacement

If the tail light lamp does not work, the lamp may need to be
replaced.
Cover
Lamp
1. Remove the two screws securing the lens cover. Remove
the lens cover.
2. Remove the lamp and replace it with a new recommended
lamp. Apply Dielectric Grease (PN 2871329) to the lamp
terminals.
3. Test the light for proper operation.
4. Reinstall the lens cover.

INDICATOR LAMPS (90CC MODELS)

Indicator Lamp Replacement

Outlaw 90 / Sportsman 90:
1. Remove the handlebar cover or pod to access the lamps.
2. Disconnect the indicator light wire connections from the
harness.
Sportsman 90
Shown
8.6
3.
Screws
4.
5.
6.
7.
8.
9.
Remove the nut from the backside of the indicator lamp.
Remove the lamp.
Install new lamp(s) into the cover or pod and secure with
retaining nut.
Apply dielectric grease to the wire connections of the new
lamp.
Reconnect wire connections and assemble the handlebar
cover or pod.
Turn ignition key to the "ON" position and shift the
transmission into "Neutral" or "Reverse" to verify light
operation.
Reverse
If the lights do not operate, check battery voltage at the light
harness and check related wiring for possible malfunction.
Sportsman 90
Shown
Neutral
Sportsman 90
Shown