Etc Switch Adjustment; Key Switch; Left Hand Switch Assembly - Polaris PREDATOR 50 2009 Manual

ELECTRICAL

ETC Switch Adjustment

1. Slide the boot off the throttle cable adjuster and jam nut.
2. Set parking brake.
3. Start engine and set idle to specified RPM.
NOTE: Be sure the
temperature. See "Idle Speed Adjustment" in
Chapter 2.
4. Loosen the adjustment nut on in–line cable adjuster.
Boot
5. Turn cable adjuster out until engine RPM begins to
increase.
6. Turn cable adjuster back in until throttle lever has 1/16"
(.16 cm) of travel before engine RPM increases.
7. Tighten lock nut securely and slide boot completely in
place to ensure a water–tight seal.
NOTE: Verify ETC switch plunger is held inward at
idle position.
8. Turn handlebars from left to right through the entire turning
range. If idle speed increases, check for proper cable
routing. If cable is routed properly and in good condition,
repeat adjustment procedure.
8.4
engine is at operating
Adjustment nut

Key Switch

The key switch can be tested with an ohm meter.
When the key switch is turned to the "ON" position, there should
be continuity between the red (RD) and brown (BN) wires.
There should also be continuity between the black (BK) and
dark green (DG) wires.
When the key is turned to the "OFF" position, there should no
continuity between any of the wires.
K S
EY WITCH
Color
RD
Switch
Position
ON
OFF

Left Hand Switch Assembly

The following illustration shows the internal operation of the
LH switch assembly. If any part of the switch is faulty, the entire
LH switch assembly must be replaced.
C C
ONTINUITY HART
BN BK DG