Transmission; Transmission Disassembly And Inspection - Polaris PREDATOR 50 2009 Manual

ENGINE / TRANSMISSION
5. Slowly rotate engine 2-3 revolutions in normal direction of
rotation. Rotate to TDC on compression stroke and verify
camshaft timing is correct.
6. If piston rings have been replaced, drain engine oil and
replace with SAE 40W mineral based oil for the first 10
hours of operation. See "Engine Lubrication" on page 3.13.
IMPORTANT: Refer to "Valve Clearance Adjustment"
in Chapter 2 to complete engine assembly.
3.32

TRANSMISSION

Transmission Disassembly and Inspection

NOTE: Engine
transmission components. Process shown below is with engine
removed for clarity. The basic disassembly and inspection
process is similar for the 50cc and 90cc models. Differences
are noted as required.
1. Drain the transmission oil from the gear case (A) and
engine oil from crankcase (B).
"T"
2. Remove oil dipstick tube (C).
3. Remove sprocket cover (D) and drive sprocket.
4. Mark shift selector shaft (E) and shift lever arm so the arm
can be reinstalled in the same location. Remove arm and
bracket.
removal is not required
B
E
D
C
to service
A