Control Arm Replacement - Polaris PREDATOR 50 2009 Manual

Control Arm Replacement

1. Elevate front end of ATV off the ground far enough to
remove the wheel.
CAUTION
Severe injury could occur if machine tips or falls.
2. Remove the dust cap and cotter pin.
3. Remove wheel nut and remove wheel and hub as an
assembly.
4. Remove the cotter pin from the upper spindle castle nut and
remove the nut.
5. Slide the spindle assembly out from the end of the control
arm.
BODY / SUSPENSION / STEERING
6. Remove the lower shock mounting fastener and inner
control arm fastener.
7. Remove control arm from the ATV.
8. To reinstall, reverse steps 1 - 7. Torque all fasteners to
specification.
Inner Control Arm Bolt Torque:
25 ft. lbs. (34 Nm)
Front Shock Mounting Bolt Torque:
25 ft. lbs. (34 Nm)
Wheel Nut Torque:
44 ft. lbs. (59 Nm)
= T
= T
= T
5.13
5