Inspection; Combination Meter - Suzuki FU150SC Manual

6-17 ELECTRICAL SYSTEM
FUEL METER
e Disconnect the speedometer lead wire coupler. (see page 4-3)
INSPECTION
To test the fuel meter two different checks may be used.
The first, connect a jumper wire between B/W and Y/W
wires coming from the main wiring harness, With the ignition
switch turned ON, the fuel meter should indicate "F". The
second test will check the accuracy of the meter in the full
and empty positions. Connect a new fuel level gauge as
shown in the illustration.
Fuel meter is normal if its pointer indicates the E (empty)
position when the specified resistance is applied to the circuit
and if its pointer indicates the F (full) position when the
resistor is changed to 11 ohms. If either one or both indications
are abnormal, replace the fuel meter with a new one.
COMBINATION METER
REMOVAL AND DISASSEMBLY
e Remove the combination meter.
e Disassemble the combination meter as follows.
O : Orange .
BMW : Black with White tracer
Y/B : Yellow with Black tracer
ELECTRICAL SYSTEM 6-18
———_—_—_—_—__$$< aa naasaass e
STEPPING MOTOR
Stator
Actor
moan
Vere
Seas
Fuel level gauge