Suzuki FU150SC Manual page 56

5-5 CHASSIS
i ee
REMOVAL AND DISASSEMBLY
FRONT WHEEL
« Remove the' axle nut.
e Remove the axle and front wheel.
INSPECTION AND DISASSEMBLY
WHEEL BEARING
e Insert the adapter @ of bearing remover to the bearing as
shown.
e Insert the wedge @ of bearing remover to the adapter from
the opposite side, lock the wedge in the slit of adapter.
ize 09941-50111 : Bearing remover
e Drive out the wheel bearing by knocking the wedge.
e Remove the remaining bearing in a similar way with a suitable
bar.
AXCAUTION
The removed bearings should be replaced with new ones.
WHEEL AXLE
Using a dial gauge, check the wheel axle for runout and replace
it if runout exceeds the limit.
09900-20606 : Dial gauge (1/100)
09900-20701 : Magnetic stand
09900-21304 : V-block set (100 mm)
Service Limit : 0.25 mm
WHEEL
Inspect the wheel runout.
Excessive runout is usually due to worn or loosen wheel bear-
ings and can be reduced by replacing the bearings. If bearing
replacement fails to reduce the runout, replace the wheel.
Service Limit (Axial and Radial) : 2.0 mm