Warning/Caution/Note; General Precautions - Suzuki FU150SC Manual

1-1 GENERAL IMFORMATION
WARNING/CAUTION/NOTE
Please read this manual and follow its instructions carefully. To emphasize special information, the symbol
and the words WARNING, CAUTION and NOTE have special meanings. Pay special attention to the
messages highlighted by these signal words.
Indicates a potential hazard that could result in death or injury.
AACAUTION
Indicates a potential hazard that could result in motorcycle damage.
NOTE:
GENERAL PRECAUTIONS
When 2 or more persons work together, pay attention to the safety of each other.
Never use gasoline as a cleaning solvent.
GENERAL IMFORMATION 1-2
AXCAUTION
If parts replacement is necessary, replace the parts with Suzuki Genuine Parts or their
equivalent.
When removing parts that are to be reused, keep them arranged in an orderly manner so that
they may be reinstalled in the proper order and orientation.
Be sure to use special tools when instructed.
Make sure that all parts used in reassembly are clean, and also lubricated when specified.
When use of a certain type of lubricant, bond, or sealant is specified, be sure to use the
specified type.
When removing the battery, disconnect the negative cable first and then the positive cable.
When reconnecting the battery, connect the positive cable first and then the negative cable,
and replace the terminal cover on the positive terminal.
When performing service to electrical parts, if the service procedures not require use of
battery power, disconnect the negative cable of the battery.
Tighten cylinder head and case bolts and nuts, beginning with larger diameter and ending with
smaller diameter, from inside to outside diagonally, to the specified tightening torque.
Whenever you remove oil seals, gaskets, packing, O-rings, locking washers, self-locking nuts,
cotter pins, circlips, and certain other parts as specified, be sure to replace them with new
ones. Also, before installing these new parts, be sure to remove any left over material from the
mating surfaces.
Never reuse a circlip. When installing a new circlip, take care not to expand the end gap larger
than required to slip the circlip over the shaft. After installing a circlip, always ensure that it is
completely: seated in its groove and securely fitted.
Use a torque wrench to tighten fasteners to the torque values when specified. Wipe off grease
or oil if a thread is smeared with them.
After reassembly, check parts for tightness and operation.
* To protect environment, do not unlawfully dispose of used motor oil and other fluids: batteries,
and tires.
* To protect Earth's natural resources, properly dispose of used motorcycles 'and parts.