Liquicap M FTI51
Endress+Hauser
21
Terminals must be connected to the isolating amplifier (NAMUR) IEC 60947-5-6
1. Connect the FEI51 according to the schema.
2. Tighten the cable gland.
3. Switch on the supply voltage.
5.4
Post-connection check
After wiring the measuring device, carry out the following checks:
Make sure that the terminal assignment is correct?
Make sure that the cable gland is sealed tight?
Make sure that the housing cover is fully screwed?
Make sure that the device is operational and the green LED flashing when the device is
on.
1 2
-
Ex ia
H
I
.
L
—
+
Electrical connection
A0042393
35