Replacement; Return; Disposal; Removing The Measuring Device - Endress+Hauser Liquicap M FTI51 Operating Instructions Manual

Repair
76
• carry out the individual test for the device
• change the device only with a device certificated by Endress+Hauser
• report every change and repair of the device
10.4

Replacement

After replacing a probe or the electronic insert, the calibration values must be transferred
to the replacement device.
Options:
• if the probe is replaced, the calibration values in the electronic insert can be transferred
to the sensor DAT (EEPROM) module via a manual download
• if the electronic insert is replaced, the calibration values of the sensor DAT (EEPROM)
module can be transferred to the electronics via a manual upload
It is possible to restart the device without having to carry out a new calibration.
10.5

Return

The requirements for safe device return can vary depending on the device type and
national legislation.
1. Refer to the website for more information:
http://www.endress.com/support/return-material
2. Return the device if repairs or a factory calibration are required, or if the wrong
device was ordered or delivered.
10.6

Disposal

10.6.1

Removing the measuring device

1. Switch off the device.
WARNING
L
Danger to personnel from process conditions.
‣
Beware of hazardous process conditions such as pressure in the measuring device, high
temperatures or aggressive fluids.
2. Carry out the mounting and connection steps from the "Mounting the measuring
device" and "Connecting the measuring device" sections in reverse order. Observe the
safety instructions.
10.6.2

Disposing of the measuring device

WARNING
L
Danger to personnel and environment from fluids that are hazardous to health.
‣
Ensure that the measuring device and all cavities are free of fluid residues that are
hazardous to health or the environment, e.g. substances that have permeated into
crevices or diffused through plastic.
Observe the following notes during disposal:
‣
Observe valid federal or national regulations.
‣
Ensure proper separation and reuse of the device components.
Liquicap M FTI51
Endress+Hauser