Hitachi CP100NX Instruction Manual page 74

3-3-1-3 Step-Mode Operation Procedures
Step Touchscreen operation
6 Check the entries displayed
for each step in the run
parameter setting/display
screen. If they are correct,
press the [X] button and
press the [X] button in the
Program registration screen.
(4) Procedures for Step-Mode Operations that Include Stops
Step Touchscreen operation
1 Call the desired program
according to the instructions
in Section 3-3-1-2
"Programmed Operation
Procedures."
In this example, program No.
11 registered in the previous
procedure is called.
Install the rotor, close the door
2
and press the [START] button
according to the instructions
in Section 3-2-5 "Operation
Procedures."
When processing samples
that are sensitive to
temperature rises, press the
[VACUUM] button to obtain a
high vacuum level in the rotor
chamber before pressing the
[START] button.
Screen displays and notes
Screen displays and notes
A run parameter called
from the program
The number of the called program is displayed in the

Program display screen.
It allows you to set and display run parameters (SPEED,

TIME, TEMP, ACEL/DECEL, ROTOR, USER).
The run time for the 0 rpm setting is not included in the

remaining run time for step operation.
The vacuum pump starts operating and temperature control

starts.
The [START] button lamp flashes and the rotor starts

turning.
The indicator of the [VACUUM] button displays the vacuum

level in the rotor chamber.
The time starts counting.

 When the set speed is reached, the [START] button lamp
changes to steady lighting and a white dot of light starts to
spin around the button.
The rotor stays in standby at 4,000 rpm until a medium

vacuum level is reached.
3-47
● The Program list
screen reappears.
[X] button
The program
registered in this
example
● The Program display
screen appears in
the run screen.
A run parameter called
from the program
Program display screen
Remaining run time for
all steps