Programmed Operation - Hitachi CP100NX Instruction Manual

3-3-1 Programmed Operation

When a centrifugal condition will be used frequently, entering the same condition every time you want
to perform centrifugation is inconvenient.
This centrifuge has a programmed operation feature that stores run parameters. Storing frequently
used run parameters allows you to call those parameters when you need them, which saves setup
time. (The stored run parameters persist even when the POWER switch is turned Off.)
As shown in the figure below, the centrifuge has a program area that can store 1,000 memory items,
each of which can hold 30 step conditions.
By storing multiple steps in a memory unit you can change the speed, run time, temperature and other
parameters during operation.
Memory unit 1
Memory unit 2
Memory unit 3





Memory unit 1,000
Step 1 Step 2
Step 1 Step 2
Step 1 Step 2
 
 
 
 
 
Step 1 Step 2
Fig. 3-3-1 Program area
3-20
3-3-1 Programmed Operation
........... Step 30
........... Step 30
........... Step 30

...........

...........

...........

...........

...........
........... Step 30