Operation - Hitachi CP100NX Instruction Manual

3. Operation

The centrifuge comes with a wide range of functions to support a broad range of applications.
A brief description of each mode of operation is given below.
Normal operation
Programmed operation
Step-mode operation
Displaying and setting
RCF (Relative
Centrifugal Force)
ω
2
T operation
3. Operation
Brief description
You can save set run parameters in memory
for later use in repeated operation.
Memory
Time
Normal operations can be combined in a
sequence of operations.
The centrifuge automatically computes RCF
values from set speed, or speed from set
values, and then displays the result of the
computation on the control panel.
RCF
The centrifuge computes run time from
speed and sets the ω
T
3-1
Time
Call
Time
Time
Time
2
T value.
Time
Reference
Section 3-2 "Basic
Operation"
Section 3-3 "How to
Use the Function
Selection Area"
Section 3-3-1
"Programmed
Operation"
Section 3-3-1-3
"Step-Mode
Operations"
Section 3-3-2
"Displaying and
Setting RCF"
Section 3-3-3 "ω2T
operation"