Table of Contents
Advertisement
Step
Touchscreen operation
Press the ω
2
18
T display area
and enter the desired value.
Example)
ω
2
T：1.98×10
19
The [Enter] button is
replaced by the [OK] button.
Check the entered value and
press the [OK] button.
12
Enter the desired value and press the [Enter] button.
The TIME (run time) computed from the SPEED value and
ω
2
the
setting value field.
To register step-mode operations, press the [Next Step]
button and enter the next run parameter.
For details, refer to Section 3-3-1-3 "Step-Mode Operation
Procedures."
NOTE
1) Pressing the [Register] button when no numeric value is
entered in the SPEED, TIME, TEMP, ACCEL or DECEL
field, will generate an error and the field where the error
occurred turns red. An inappropriate setting value will also
cause the field with the error to be displayed in red.
Example: When SPEED and TIME are not set
Be
2)
sure to set the SPEED, TIME, TEMP, ACCEL and DECEL
run parameters.
performed without entering RCFmax, RCFavg and ω
3) RCFmax and RCFavg cannot be registered without installing
a rotor.
ω
2
4)
T cannot
3-3-1-1 Program Registration Procedures
Screen displays and notes
T
value set in steps 17 and 18 is displayed in the TIME
(Program registration and operation can be
be registered without setting
3-30
ω
2
The
setting
●
T
screen appears.
ω
2
display
T
(Left area) Mantissa
(Right area) Exponent
The run parameter
●
entry/display screen
reappears.
[Next Step] button
[Register] button
2
T.)
.
SPEED
Advertisement
Table of Contents
