Step-Mode Operation Procedures - Hitachi CP100NX Instruction Manual

Step Touchscreen operation
4
5 Do not change the run
parameters after starting a
run.
Screen displays and notes
The number of the called program is displayed in the

Program display screen.
It allows you to set and display run parameters (SPEED,

TIME, TEMP, ACEL/DECEL, ROTOR, USER).
 The Program display screen displays the following data.
Current step no.
Program No.
For details regarding step mode operation, refer to "(2)
Step-Mode Operation Procedures" in Section 3-3-1-3

"Step-Mode Operation Procedures"

Operate the centrifuge according to the instructions in

Section 3-2-5 "Operation Procedures."
NOTE
Reentering (changing) the run parameters (for example,
SPEED, TIME, etc.) after calling a program will cancel a
called program.
3-38
3-3-1-2 Programmed Operation Procedures
Total number of
registered steps
Remaining run time
for all steps