Table of Contents
Advertisement
3-3 How to Use the Function Selection Area
3-3 How to Use the Function Selection Area
This centrifuge provides programmed operation including step-mode operation, RCF display and setting
function, ω
2
T display and setting function and Real Time Control (RTC) that can run the centrifuge at a
preset date and time and a host of other functions. These features are displayed and controlled using the
Function Selection Area in the Run screen.
[PROGRAM] button
[RCF] button
Name
Program
RCF
ω
2
T
RTC
The above features can be used in combination.
NOTE
To combine [PROGRAM] and [RTC], first set [PROGRAM] and then [RTC]. Once
[RTC] is activated, you cannot change the run time and set [PROGRAM].
Icon
(Button)
You can save run parameters in memory for later use in repeated
operation. This feature also allows step-mode operation that can
combine a number of run parameters in a sequence of operations.
The centrifuge automatically computes and displays RCF values
from set speed, or speed from set RCF values.
This function is used to indicate ω
run time to the angular velocity squared), the centrifugal effect.
Operation can be stopped when the set ω
Sets a start time or end time and runs the centrifuge at a desired
date and time.
Fig. 3-3 Run screen
Function
3-19
Function
Selection Area
[RTC] button
[ω
2
T] button
2
T, (a value obtained by adding
2
T value is obtained.
Advertisement
Table of Contents
