Bri-S Terminal Interfaces - Mitel SMB Controller System Manual

C 4
HAPTER
Installation rules
• If a Mitel DECT radio unit is used, do not connect any other system phone to the same DSI bus.
• Do not use any terminating resistors at the bus extremity.
• Avoid using different cable cross-sections on the same bus
• Use the supplied cables for connecting the system phones
• Cabling of AD2 terminals is restricted to pairs of a separate dedicated cable(s).
Terminals
The following system terminals can be operated on the DSI-AD2 bus:
• MiVoice 5300 series system phones
• Mitel DECT radio units
The system phones on an DSI-AD2 bus are addressed via a single-digit terminal selection digit (TSD).
Example:
The address of a system phone with TSD 2 on DSI interface 3.5 is 3.5-2.

BRI-S terminal interfaces

: Some of the interfaces can be configured on BRI-T using the wiring adapters (see
NOTE
adapter).
Connection
Table 4.24:Connection of BRI-S terminal interfaces (Sheet 1 of 2)
Communication server
Socket Pin
1. Applies in Australia only
Figure 4.34: Connection possibilities for BRI-S terminal interfaces
Cable
cores
BRI-S
signal
Connection socket
BRI-S Pin
signal
C
ABLING INTERFACES
I
NSTALLATION
1
.
Fitting a wiring
Socket
130