Table of Contents
Advertisement
C
4
HAPTER
Cable Requirements
Table
4.18:Cable requirements for FXO network interface
Core pairs X cores
Stranded
Wire diameter, core
Screening
Resistance
Terminal interfaces
The number of available terminal interfaces on the mainboard can be increased by fitting interface cards.
The RJ45 connector assignment is the same for interfaces of the mainboard and terminal cards.
DSI terminal interfaces
With interface cards EADP4 and the appropriate wiring adapters, DSI terminal interfaces can be made
available at the RJ45 sockets 1.x...4.x. The possible RJ45 sockets are highlighted in colour in the figure
below.
Figure 4.29:
With interface cards 8DSI
available at the multiply assigned RJ45 sockets x.1 and x.2. The signals can be split again to individual
RJ45 sockets using patch cables and the fan-out panel FOP (see
assigned connecting cables (see e.g.
are highlighted in colour in the figure below.
Figure 4.30:
1. Not yet supported with Release 6.0
Connection possibilities for DSI terminal interfaces on single assigned RJ45
1
and the appropriate wiring adapters, DSI terminal interfaces can be made
Prefabricated system cable 4 x
Connection possibilities for DSI terminal interfaces on multiply assigned RJ45
1 X 2
not required
0.4 ... 0.8 mm
not required
max. 2 X 250 W
sockets
Fan-out panel
sockets
C
ABLING INTERFACES
FOP, ) or with 8-fold
RJ45).The possible RJ45 sockets
I
NSTALLATION
122
Advertisement
Table of Contents
