Power Supply Capacity - Mitel SMB Controller System Manual

C 3
HAPTER
Table 3.18:Overview of licences (Continued) (Sheet 11 of 11)
ATAS Use of the ATAS
Interface interface
ATASpro Use of the
Interface ATASpro interface
CSTA Number of
Sessions monitored
terminals via the
CSTA protocol.
Presence Number of users
Sync. via who can use one
SIMPLE and (or both)
MSRP protocols for the
third-party
applications.
OAI Use of the Open
Interface Application
Interface
1. 4 hours after the new software has been uploaded or after a restart operation, the communication server switches over to
a restricted operating mode (see
2. The licences can also be used if the Mitel SIP Terminals licences are missing.
3. This licence is not viewable in the licence overview in WebAdmin.
4. If Virtual Appliance is used as Master, the VoIP channels of the master node are made available without a licence from the
integrated Mitel Media Server. However, for the satellites' VoIP channels, the licences must be purchased.
5. If VoIP mode is set to G.711, two G.711 VoIP channels per system can be used without a licence.
6. For Virtual Appliance this licence is only relevant to the QSIG networking of an AIN satellite.

Power supply capacity

The maximum number of terminals connected to the system can be limited by the supply power available
for terminals. It is also important to take note of the maximum load per terminal interface.
Locked Enabled
Locked Enabled
0 1, 20, 50 or
100 CSTA
sessions per
licence
0 1, 20 or 50
additional
users per
licence who
may use
both
protocols.
Locked Enabled
Restricted operating mode).
E S
XPANSION TAGES AND
In the AIN, –
only on the
Master;
otherwise
per node.
In the AIN, –
only on the
Master;
otherwise
per node.
In the AIN, yes
only on the
Master;
otherwise
per node.
In the AIN, yes
only on the
Master;
otherwise
per node.
In the AIN, –
only on the
Master;
otherwise
per node.
P
OWER SUPPLY CAPACITY
S C
YSTEM APACITY
yes
yes
yes
yes
yes
86