Table of Contents
Advertisement
C
6
HAPTER
Table
6.9:Enter shut-down mode (Continued) (Sheet 2 of 2)
[17]
Special functions
The pilot key is used to carry out various functions. For certain functions the system has to be in a partic-
ular operating state beforehand.
Shutting down the SMB Controller
The SMB Controller must be shut down in a controlled manner. This is described in chapter
mode).
Reset the IP address data
The IP address data of the SMB Controller is stored in a flash chip and is retained, even after a first start
of the MiVoice Office 400 call manager. The following sequence only resets the IP address data of the
SMB Controller to the default values. All other data is retained.
The SMB Controller is in normal mode or in emergency mode
1.
–
For normal mode: The pattern
Press the pilot key (CTRL) 5 times within a time frame of 5 seconds.
2.
–
Each time you press the pilot key, the F1 - F5 LED lights up orange one by one
(Example: After 2 clicks, pattern
–
After the fifth key press, the F1 - F5 LED are switched off and the F0 LED lights up orange to
indicate, that the fixed default IP address is set (pattern [20]).
–
You can now reach the SMB Controller with the default IP address.
Default values of the IP address data:
•
IP address: 192.168.104.13
•
Subnet mask: 255.255.255.0
•
Gateway: 0.0.0.0
Table
6.10:Reset the IP address data (Sheet 1 of 2)
No.
PWR
F0
is showed.
[18]
[19]
F1
F2
F3
is showed).
F4
F5
D
ISPLAY AND CONTROL PANEL
O
PERATION AND
~90s
F6
SYS
Durat
ion
M
AINTENANCE
SMB
Contr
oller
is in
shut-
down
mode
Shut-down
Mean
ing
204
Advertisement
Table of Contents
