Installing The Cable Cover - Mitel SMB Controller System Manual

C 4
HAPTER
Secure the cage nuts in the appropriate positions in the rack's fastening rails (see
7.
communication servers above each other inside a 19"
Secure the communication server to the rack's fastening rails using the M6 screws, the plastic
8.
washers and the cage nuts.
Fasten the snap-on tag to the front panel.
9.
Reconnect the communication server to the power supply.
10.

Installing the cable cover

Materials required:
• Cable cover set
• Screwdriver
To install the cable cover proceed as follows:
Pull off the screw covers on the left and right of the front panel.
1.
Use the M4 screws of the cable cover set to secure the brackets for the cable cover to the commu-
2.
nication server.
: The two brackets are not identical. Compare the cable brackets with the ones in
NOTE
brackets for the cable
Fit the cable cover over the brackets from above until they are felt to engage.
3.
: To remove the cable cover reach into the side openings of the cover, gently press the two (engaged)
TIP
lugs outwards and remove the cover.
cover.
Figure 4.7:
Figure 4.8:
rack).
Installing the brackets for the cable cover
Installing the brackets for the cable cover
F
ITTING THE COMMUNICATION SERVER
I
NSTALLATION
Placing two
Installing the
98