Hardware Installation; Before You Begin; Installing The Unit On A Flat Surface; Before You Start - Mitel MiVoice Business EX Controller Installation Manual

EX Controller Installation Guide

HARDWARE INSTALLATION

BEFORE YOU BEGIN

Note or take a picture of your unit's serial number before starting the installation,
and place the card stickers of the cards not factory installed. Refer to Locating the
Product Serial Number.

INSTALLING THE UNIT ON A FLAT SURFACE

BEFORE YOU START

WARNING: Before performing this procedure, you must first
read and understand the Safety Recommendations listed in
this document.
Steps
1. Unpack the unit and go through the Package Check List
2. Apply the Bumpon™ autoadhesive protective products to the bottom
of the unit.
Note: This will improve the airflow under the unit.
3. Install the unit on the flat surface.
4. Make sure the unit is at 20 cm (8 in.) from your monitor, computer
casing, or other peripheral, including speakers.
20