Erase; Replace - Tele Radio TIGER G2 Installation Instructions Manual

ERASE

WARNING! If a transmitter is lost or becomes seriously damaged, it is possible to erase it from the
receiver. We do not recommend this way. Contact your representative for assistance.
NOTE! If the transmitter already have receivers registered, we recommend that you erase all receivers
from the transmitter before starting the replacement. The receiver will automatically be stored in the
same position as it was stored in the old transmitter. If this position is not available, the replacement will
not take place.
1. Make sure that the stop button is pressed.
2. Twist and pull out the stop button.
The top LED lights (green when the battery capacity is good, red when the battery capacity is poor).
3. Press the right start button. Keep pressed.
4. Press the stop button.
5. Release the right start button.
The top LED flashes (green when the battery capacity is good, red when the battery capacity is poor)
when in menu mode.
6. Go to [Erase].
7. Select by pressing the left start button.
8. Select a receiver. Confirm by pressing the left start button. The display shows [Erasing] while the
process is ongoing.
If the erasing fails, the display shows [FAILED]. The transmitter turns off.
If the erasing succeeds, the display shows [OK]. The transmitter turns off.

REPLACE

WARNING! Do not perform this when the receiver is in a session with another transmitter. The radio
communication may become disturbed or broken.
NOTE! You can replace a registered transmitter with another transmitter without having access to the
receiver.
NOTE! If the transmitter that needs to be replaced is registered in more than one receiver, it will only
be replaced in one receiver at a time. If you want to replace a transmitter in more than one receiver, you
need to perform a replacement for each receiver.
NOTE! If the transmitter already have receivers registered, we recommend that you erase all receivers
from the transmitter before starting the replacement. The receiver will automatically be stored in the
same position as it was stored in the old transmitter. If this position is not available, the replacement will
not take place.
Replace a transmitter with a new transmitter
1. Make sure that the stop button is pressed.
- 53 -