Table of Contents
Advertisement
REPLACE
You can replace a registered transmitter with another transmitter without having access to the
receiver.
IMPORTANT! Do not perform this when the receiver is in a session with another transmitter. The
radio communication may become disturbed or broken.
IMPORTANT! If the transmitter that needs to be replaced is registered in more than one receiver,
it will only be replaced in one receiver at a time. If you want to replace a transmitter in more than
one receiver, you need to perform a replacement for each receiver.
NOTE! If the new transmitter already has r eceivers registered, we recommend that you erase all
receivers from the transmitter before starting the replacement. The receiver will a utomatically be
stored in the same position as it was stored in the old transmitter. If this position is not available,
the replacement will not take place.
Replace a transmitter with a new transmitter
1. Make sure that the stop button is pressed.
2. Pull out the stop button.
The top LED lights (green when the battery capacity is good, red when the battery capacity is
poor).
3. Press the right start button. Keep pressed.
4. Press the stop button.
5. Release t he right start button.
The top LED flashes (green when the battery capacity is good, red when the battery capacity is
poor) when in menu mode.
6. Press button 3.
7. Enter the serial number/ ID code for the transmitter that you want to replace by pressing the
buttons according to the table below:
TG-TX-MNL8, TG-TX-MNR8:
DIGITS
BUTTON TO PRESS
1
1
2
2
3
3
4
4
5
5
6
6
7
the right start button + 1
8
the right start button + 2
9
the right start button + 3
0
the right start button + 4
8. Press the left start button.
When completed successfully, the top LED lights green. If not completed successfully within 25
seconds, the top LED lights red and the transmitter turns off.
TG-TX-MXL12, TG-TX-MXR12:
BUTTON TO PRESS
1
2
3
4
5
6
7
8
9
10
- 11 -
Advertisement
Table of Contents
