Danfoss VLT HVAC Drive FC 131 Programming Manual page 41

VLT® HVAC Drive FC 131
Programming Guide
Table 29: Option:
[0] Disabled
[1] Enabled
0-44 [Off/Reset] Key on LCP
Default value: [1] Enabled
Conversion index: -
Table 30: Option:
[0] Disabled
[1] Enabled
[7] Enable Reset Only
4.2.5 0-5* Copy/Save
Copy parameter settings between setups and to/from the LCP.
0-50 LCP Copy
Default value: [0] No copy
Conversion index: -
Table 31: Option:
[0] No copy No action.
[1] All to LCP Copy all parameters in all setups from the drive memory to the LCP memory. For service purposes,
copy all parameters to the LCP after commissioning.
[2] All from LCP Copy all parameters in all setups from the LCP memory to the drive memory.
[3] Size indep. from Copy only the parameters that are independent of the motor size. The latter selection can be used to
LCP program several drives with the same function without disturbing motor data that is already set.
[10] Delete LCP copy Delete copied parameters in LCP. This function requires that LCP version is greater than or equal to
data V11.00.
0-51 Set-up Copy
Default value: [0] No copy
Conversion index: -
Table 32: Option:
[0] No copy
[1] Copy from setup 1
[2] Copy from setup 2
[9] Copy from factory setup
4.2.6 0-6* Password
This parameter group defines password to access menus.
Danfoss A/S © 2022.05
To avoid unintended start of the drive, select [0] Disabled.
[Auto On] is enabled.
Parameter type: Option
Data type: u_int8
Disable the [Off/Reset] key.
Enable both off and reset functions.
Enable the reset function, and disable the off function to avoid unintended stop of the drive.
Parameter type: Option
Data type: u_int8
Parameter type: Option
Data type: u_int8
No action.
Copy from setup 1 to setup 2.
Copy from setup 2 to setup 1.
Copy factory setting to programming setup (selected in parameter 0-11 Programming Set-up).
2-setup: All setups
Change during operation: True
2-setup: 1 setup
Change during operation: False
2-setup: 1 setup
Change during operation: False
AU370727746889en-000101 / 130R0994 | 41
Parameters