Danfoss VLT HVAC Drive FC 131 Programming Manual page 15

VLT® HVAC Drive FC 131
Programming Guide
Parameter Option/range
Parameter 1-20 0.18–110 kW/0.25–150 hp
Motor Power
Parameter 1-22 50–1000 V
Motor Voltage
20–400 Hz
Parameter 1-23
Motor Frequen-
cy
0.01–1000.00 A
Parameter 1-24
Motor Current
Parameter 1-25 50–9999 RPM
Motor Nominal
Speed
0.1–1000.0 Nm
Parameter 1-26
Motor Cont.
Rated Torque
Danfoss A/S © 2022.05
Default Usage
• Parameter 1-37 d-axis Inductance (Ld).
• Parameter 1-38 q-axis Inductance (Lq).
•
Parameter 1-39 Motor Poles.
•
Parameter 1-40 Back EMF at 1000 RPM.
•
Parameter 1-44 d-axis Inductance Sat. (LdSat).
•
Parameter 1-45 q-axis Inductance Sat. (LqSat).
•
Parameter 1-46 Position Detection Gain.
• Parameter 1-48 Current at Min Inductance for d-axis.
• Parameter 1-49 Current at Min Inductance for q-axis.
• Parameter 1-66 Min. Current at Low Speed.
• Parameter 1-70 PM Start Mode.
•
Parameter 1-72 Start Function.
•
Parameter 1-73 Flying Start.
•
Parameter 1-80 Function at Stop.
•
Parameter 1-82 Min Speed for Function at Stop [Hz].
•
Parameter 1-90 Motor Thermal Protection.
•
Parameter 2-00 DC Hold/Motor Preheat Current.
• Parameter 2-01 DC Brake Current.
• Parameter 2-02 DC Braking Time.
• Parameter 2-04 DC Brake Cut In Speed.
• Parameter 2-10 Brake Function.
•
Parameter 4-14 Motor Speed High Limit [Hz].
•
Parameter 4-19 Max Output Frequency.
•
Parameter 4-58 Missing Motor Phase Function.
•
Parameter 14-65 Speed Derate Dead Time Compensation.
Size related Enter the motor power from the nameplate data.
Size related Enter the motor voltage from the nameplate data.
Size related Enter the motor frequency from the nameplate data.
Size related Enter the motor current from the nameplate data.
Size related Enter the motor nominal speed from the nameplate data.
Size related
This parameter is available when parameter 1-10 Motor Con-
struction is set to options that enable permanent motor
mode.
Programming
AU370727746889en-000101 / 130R0994 | 15