Danfoss VLT HVAC Drive FC 131 Programming Manual page 111

VLT® HVAC Drive FC 131
Programming Guide
[35] Digital input DI27
[36] Digital input DI29
[39] Start command
[40] Drive stopped
[42] Auto Reset Trip
[50] Comparator 4
[51] Comparator 5
[60] Logic rule 4
[61] Logic rule 5
[83] Broken Belt
13-02 Stop Event
Default value: [40] Drive stopped
Conversion index: -
Select the condition (True or False) which deactivates the smart logic controller.
Table 216: Option:
[0] False
[1] True
[2] Running
[3] In range
[4] On reference
[7] Out of current range
[8] Below I low
[9] Above I high
[16] Thermal warning
[17] Mains out of range
[18] Reversing
[19] Warning
[20] Alarm (trip)
[21] Alarm (trip lock)
[22] Comparator 0
[23] Comparator 1
[24] Comparator 2
[25] Comparator 3
Danfoss A/S © 2022.05
Use the value of DI27 in the logic rule (High = True).
Use the value of DI29 in the logic rule (High = True).
This event is True if the drive is started by any means (either via digital input, or other).
This event is True if the drive is stopped or coasted by any means (either via digital input, or other).
This event is True if the drive is tripped (but not trip-locked) and an automatic reset is issued.
Use the result of comparator 4 in the logic rule.
Use the result of comparator 5 in the logic rule.
Use the result of logic rule 4 in the logic rule.
Use the result of logic rule 5 in the logic rule.
A broken-belt condition has been detected. Enable this function in parameter 22-60 Broken Belt
Function.
Parameter type: Option
Data type: u_int8
Enter the fixed value False in the logic rule.
Enter the fixed value True in the logic rule.
See parameter 13-01 Start Event for further description.
See parameter 13-01 Start Event for further description.
See parameter 13-01 Start Event for further description.
See parameter 13-01 Start Event for further description.
See parameter 13-01 Start Event for further description.
See parameter 13-01 Start Event for further description.
See parameter 13-01 Start Event for further description.
See parameter 13-01 Start Event for further description.
See parameter 13-01 Start Event for further description.
See parameter 13-01 Start Event for further description.
See parameter 13-01 Start Event for further description.
See parameter 13-01 Start Event for further description.
Use the result of comparator 0 in the logic rule.
Use the result of comparator 1 in the logic rule.
Use the result of comparator 2 in the logic rule.
Use the result of comparator 3 in the logic rule.
2-setup: 1 setup
Change during operation: True
AU370727746889en-000101 / 130R0994 | 111
Parameters