Danfoss VLT HVAC Drive FC 131 Programming Manual page 147

VLT® HVAC Drive FC 131
Programming Guide
Table 331: Bit Definitions
Bit 0–2
Bit 3
Bit 4
Bit 5–15
Table 332: Range:
Min: 0
16-72 Counter A
Default value: 0
Conversion index: 0
View the present value of counter A. Counters are useful as comparator operands, see parameter 13-10 Comparator Operand. The
value can be reset or changed either via digital inputs (parameter group 5-1* Digital Inputs) or by using an SLC action (parameter
13-52 SL Controller Action).
Table 333: Range:
Min: -32768
16-73 Counter B
Default value: 0
Conversion index: 0
View the present value of counter B. Counters are useful as comparator operands, see parameter 13-10 Comparator Operand. The
value can be reset or changed either via digital inputs (parameter group 5-1* Digital Inputs) or by using an SLC action (parameter
13-52 SL Controller Action).
Table 334: Range:
Min: -32768
16-79 Analog output 45 [mA]
Default value: 0 mA
Conversion index: -2
View the actual value at output 45 in mA. The value shown reflects the selection in parameter 6-70 Terminal 45 Mode and parameter
6-71 Terminal 45 Analog Output.
Table 335: Range:
Min: 0 mA
4.13.6 16-8* Fieldbus & FC Port
Parameters for reporting the bus references and control words.
16-86 FC Port REF 1
Default value: 0
Conversion index: 0
View the last received reference from the FC port.
Danfoss A/S © 2022.05
Max: 31
Parameter type: Range
Data type: int16
Max: 32767
Parameter type: Range
Data type: int16
Max: 32767
Parameter type: Range
Data type: u_int16
Max: 20 mA
Parameter type: Range
Data type: int16
Unused
Relay 02
Relay 01
Unused
Default value: 0
2-setup: 1 setup
Change during operation: True
Default value: 0
2-setup: 1 setup
Change during operation: True
Default value: 0
2-setup: 1 setup
Change during operation: True
Default value: 0 mA
2-setup: 1 setup
Change during operation: True
AU370727746889en-000101 / 130R0994 | 147
Parameters