Danfoss VLT HVAC Drive FC 131 Programming Manual page 107

VLT® HVAC Drive FC 131
Programming Guide
Table 202: Option:
[0] Send at power-up
Select when the device should send the I am service message only at power-up.
[1] Continuously Select when the device should send the I am service message continuously with an interval of approxi-
mately 1 minute.
8-75 Intialisation Password
Default value: admin
Conversion index: 0
Enter the password needed for execution of Drive Re-initialization from BACnet.
Table 203: Range:
Min: 1
8-79 Protocol Firmware version
Default value: 0
Conversion index: -2
Firmware revision of the drive is in index 0, Modbus is in index 1, Metasys N2 is in index 2, FLN is in index 3, BACnet is in index 4.
Table 204: Range:
Min: 0
4.9.6 8-8* FC Port Diagnostics
These parameters are used for monitoring the bus communication via the FC port.
8-80 Bus Message Count
Default value: 0
Conversion index: 0
This parameter shows the number of valid telegrams detected on the bus.
Table 205: Range:
Min: 0 Max: 4294967295
8-81 Bus Error Count
Default value: 0
Conversion index: 0
This parameter shows the number of telegrams with faults (for example, CRC fault), detected on the bus.
Table 206: Range:
Min: 0 Max: 4294967295
8-82 Slave Messages Rcvd
Default value: 0
Conversion index: 0
This parameter shows the number of valid telegrams addressed to the slave, sent by the drive.
Danfoss A/S © 2022.05
Parameter type: Range
Data type: VisibleString
Max: 1
Parameter type: Range
Data type: u_int16
Max: 655
Parameter type: Range
Data type: u_int32
Parameter type: Range
Data type: u_int32
Parameter type: Range
Data type: u_int32
2-setup: 1 setup
Change during operation: True
Default value: admin
2-setup: 1 setup
Change during operation: False
Default value: 0
2-setup: 1 setup
Change during operation: True
Default value: 0
2-setup: 1 setup
Change during operation: True
Default value: 0
2-setup: 1 setup
Change during operation: True
Parameters
AU370727746889en-000101 / 130R0994 | 107