Danfoss VLT HVAC Drive FC 131 Programming Manual page 20

VLT® HVAC Drive FC 131
Programming Guide
Table 7: Setup Wizard for Closed-loop Applications
Parameter Option/range
Parameter 0-03
[0] International
Regional Set-
[1] US
tings
Parameter 0-06
[0] 200–240 V/50 Hz/IT-grid
GridType
[1] 200–240 V/50 Hz/Delta
[2] 200–240 V/50 Hz
[10] 380–440 V/50 Hz/IT-grid
[11] 380–440 V/50 Hz/Delta
[12] 380–440 V/50 Hz
[20] 440–480 V/50 Hz/IT-grid
[21] 440–480 V/50 Hz/Delta
[22] 440–480 V/50 Hz
[30] 525–600 V/50 Hz/IT-grid
[31] 525–600 V/50 Hz/Delta
[32] 525–600 V/50 Hz
[100] 200–240 V/60 Hz/IT-grid
[101] 200–240 V/60 Hz/Delta
[102] 200–240 V/60 Hz
[110] 380–440 V/60 Hz/IT-grid
[111] 380–440 V/60 Hz/Delta
[112] 380–440 V/60 Hz
[120] 440–480 V/60 Hz/IT-grid
[121] 440–480 V/60 Hz/Delta
[122] 440–480 V/60 Hz
[130] 525–600 V/60 Hz/IT-grid
[131] 525–600 V/60 Hz/Delta
[132] 525–600 V/60 Hz
Parameter 1-00
[0] Open loop
Configuration
[3] Closed loop
Mode
Parameter 1-10
*[0] Asynchron
Motor Con-
[1] PM, non-salient SPM
struction
[3] PM, salient IPM
20 | Danfoss A/S © 2022.05
Default Usage
–
[0] Interna-
tional
Size selected Select the operating mode for restart after reconnection of
the drive to mains voltage after power down.
[0] Open loop Select [3] Closed loop.
[0] Asynchron Setting the parameter value might change these parame-
ters:
• Parameter 1-01 Motor Control Principle.
• Parameter 1-03 Torque Characteristics.
• Parameter 1-08 Motor Control Bandwidth.
•
Parameter 1-14 Damping Gain.
•
Parameter 1-15 Low Speed Filter Time Const.
•
Parameter 1-16 High Speed Filter Time Const.
•
Parameter 1-17 Voltage Filter Time Const.
•
Parameter 1-20 Motor Power.
• Parameter 1-22 Motor Voltage.
• Parameter 1-23 Motor Frequency.
• Parameter 1-24 Motor Current.
• Parameter 1-25 Motor Nominal Speed.
• Parameter 1-26 Motor Cont. Rated Torque.
Programming
AU370727746889en-000101 / 130R0994