Table of Contents
Advertisement
42 Chapter 4: Matrox GatorEye feature reference
3. If a Matrox GatorEye feature is not already set to the required value, call
MdigControlFeature() to change the value of the feature.
4. When all operations are complete, free your MIL buffers, digitizer(s), GigE Vision
system, and application.
Matrox GatorEye GenICam-extension
features
This section lists Matrox GatorEye GenICam-extension features and their possible
settings. For a complete list of GenICam-standard features, refer to the GenICam
Standard Feature Naming Convention.
❖ Note that the Matrox GatorEye-specific dedicated trigger line is referred to as
LineTrig. Auxiliary input and output lines are referred to as lines. In these cases,
lines are not rows in an image.
Additional values for source selector features
The Matrox GatorEye GenICam-extension provides 8 new values that can be used
with any of the following features: Counter Event Source, Counter Reset Source,
Counter Trigger Source, Timer Selector Source, and Trigger Source.
❖ Note that, for definitions of these GenICam-standard features, as well as the list
of additional GenICam-standard values supported by these features, refer to the
GenICam Standard Feature Naming Convention.
Advertisement
Table of Contents
