Inspecting Your Matrox Gatoreye Package; Base Package; Available Separately - Matrox GatorEye Series Installation And Technical Reference

Table of Contents

Advertisement

Inspecting your Matrox GatorEye package

You should check the contents of your Matrox GatorEye package when you first
open it. If something is missing or damaged, contact your Matrox sales
representative.

Base package

If you have purchased Matrox GatorEye, your package should include a Matrox
GatorEye camera.
❖ Note that the Matrox GatorEye base package does not include any cables, a power
supply, connection module, or a manual iris lens. To purchase these items, contact
a Matrox sales representative.

Available separately

You might have also ordered one or more of the following cables:
• GT-CBL-PWRDB25*, a digital I/O and power cable. On one end is an M12
17-pin (female) connector and a DB-25 connector on the other. This cable is
meant to connect your Matrox GatorEye to your Matrox Breakout Box, to obtain
power (if not using power-over-Ethernet) and connect with third-party digital I/O
devices.
• GT-CBL-ETH/5*, a 100/1000BaseT cable with an M12 8-pin (male) connector
on one end and an RJ-45 registered jack on the other. For more details about this
cable, refer to the 100/1000 BaseT connector subsection of the Matrox GatorEye
connectors section, in Appendix B: Technical Reference. This cable is meant to
connect your Matrox GatorEye to another computer or network device.
• BREAKOUT-BOX* (Matrox Breakout Box), a DIN-rail mountable connection
module that connects the digital I/O and power cable of your Matrox GatorEye
to third-party devices. Your Matrox Breakout Box also connects to a serial cable,
allowing you to view the RS-232 (serial) information from your Matrox GatorEye
(transmitted over the digital I/O and power cable) through a terminal emulation
program. Signals on Matrox GatorEye auxiliary I/O lines can be routed either
through standard wire terminals or through opto-isolated paired wire terminals.
Each pair of opto-isolated wire terminals has a separate connector for a G4
Opto-22 standard I/O module; these modules provide high noise rejection, the
ability to safely connect high voltage equipment (either AC or DC) to your Matrox
Inspecting your Matrox GatorEye package
11

Advertisement

Table of Contents
loading

Table of Contents