Table of Contents
Advertisement
• Step 6:
Apply glue (Loctite 5772) on the 2 screws (7.1.1.2.1).
Screw them by means of a n°6 hex key.
Tightening torque: 17 N.m. / 12.5 Ft.Lbs
• Step 7:
Install the ground wire (7.1.1.3) on the geared motor
(7.1.1.1).
Tighten the locking screw (A) by means of a 10 mm flat
wrench.
IMPORTANT : Please refer to ground section
page
12.
• Step 8:
IMPORTANT : To prevent injury or damage, the propellers
are wrapped.
Place the upper propeller (7.1.3) on the agitator rod (7.1.2).
Tighten the screw (E) by means of a 8 mm flat wrench.
Tightening torque: 17 N.m. / 12.5 Ft.Lbs
Member of Exel group
see § 1.5. 1
E
79
7.1.1.2.1
7.1.1.3
A
7.1.1.1
1
7.1.2
2
DRT582350110
7.1.3
A - 2023/10
Advertisement
Table of Contents
