Table of Contents
Advertisement
• Step 8:
Apply glue (Loctite 5772) on the 2 screws (7.1.1.2.1).
Screw them by means of a n°6 hex key.
Tightening torque: 17 N.m. / 12.5 Ft.Lbs
• Step 9:
Install the ground wire (7.1.1.3) on the geared motor
(7.1.1.1).
Tighten the locking screw (A) by means of a 10 mm flat
wrench.
IMPORTANT : Please refer to ground section
page
12.
• Step 10:
Install the suction rod (8.1) as well as the strainer (8.1.1).
Tighten the nut (B) by means of a spanner wrench.
Tighten the ring (C).
Member of Exel group
see § 1.5. 1
62
7.1.1.2.1
7.1.1.3
A
7.1.1.1
1
2
3
1
8.1
8.1.1
DRT582350110
B
C
A - 2023/10
Advertisement
Table of Contents
