Table of Contents
Advertisement
• Step 7:
Untighten the 2 screws and the 2 nuts of the control (2)
ram (1) by means of a 7 mm flat wrench and a n°3 hex key.
Remove the ram control (2) from the ram (1).
• Step 8:
Unscrew the nut (1.4) and the washer (1.5) by means of a
30 mm flat wrench from the ram lever-arm to remove it.
• Step 9:
Remove the circlips (4) with the circlips pliers.
Take off the jack ram to change the ram seals.
Member of Exel group
2
43
1
1.4
1.5
4
DRT582350110
A - 2023/10
Advertisement
Table of Contents
