Shutdown And Start-Up Procedures; Shutdown And Replacement Of The Drum Procedures - SAMES KREMLIN Cyclix 200 L Instruction Manual

5.3. Shutdown and start-up procedures

5.3.1. Shutdown and replacement of the drum procedures

Before any intervention, respect the health and safety instructions
Before any work is carried out on the system during shutdown, assembly, cleaning or replacement of parts, shut the
air and carry out the following procedure:
• Close the air supply by unscrewing the knob of the air regulator. The motor of the agitator stops.
• Disconnect the air hose that supplies the agitator motor.
• Connect the quick release fitting to the air inlet of the pneumatic control of the simple-post ram.
• Open the air.
• Move the distributor lever upwards to raise the assembly.
5.3.1.1. Drum replacement procedure
• Close the air supply by unscrewing the knob of the air regulator. The motor of the agitator stops.
• Disconnect the air hose that supplies the agitator motor.
• Connect the quick release fitting to the air inlet of the pneumatic control of the simple-post ram.
• Open the air.
• Move the distributor lever upwards to raise the assembly.
• Take off the empty drum.
• Check that the tightening of the motor is correct.
• Place the new drum under the cover of the simple-post ram.
• Lower the assembly, holding the distributor lever down.
IMPORTANT : Center the drum in respect of the cover so as not to damage.
• Bring into contact the cover with the drum, to shut off the air.
• Disconnect the quick release fitting of the pneumatic control of the simple-post ram and connect it to the
agitator air inlet.
• Open the air supply screwing the knob of the air regulator. The motor of the agitator starts up.
Member of Exel group 35
see § 1 page 6.
DRT582350110
A - 2023/10