• Step 5:
Place the geared motor (7.1.1.1) of the agitator (7) in the
centre of the cover (6).
Tighten it by means of the 4 screws (7.1.1.4) and of the 8
washers (7.1.1.5 & 7.1.1.6) by means of a 13 mm flat
wrench.
Tightening torque: 17 N.m. / 12.5 Ft.Lbs
• Step 6:
Apply glue (Loctite 270) on the thread of the adapter
(7.1.1.2.2).
Insert it and fix it on the shaft of the geared motor by
means of two 24 mm flat wrenches.
Tightening torque: 35 N.m. / 25.8 Ft. Lbs
Install the agitator rod (7.1.2) in the adapter (7.1.1.2.2) of
the geared motor (7.1.1.1).
Member of Exel group
7.1.1.1
6
7.1.1.6
7.1.1.5
7.1.1.4
7.1.1.1
7.1.1.2.2
7.1.2
26
1
2
DRT582350110
A - 2023/10