LinMot SM01-37 Installation Manual page 36

Installation Guide Linear Modules
Shaft seals
Page 36 / 85
Shaft seals
SM01-37 / SM01-48
3. Fix new guide shafts to the front plate
Apply Loctite 243 threadlocker to the threaded
hole of the guide shafts.
Then fasten the front plate (2) temporarily with
the guide shafts (1).
Linear modules with linear ball
bearings have shaft seals fitted in the
front plate and back plate. These must
remain installed when the guide shafts
are replaced.
4. Screw the new guide shafts tightly to the
front plate
(1) Slide the front plate to the stop of the guide
block.
(2) Tighten the screws.
Tightening torque: 18 Nm
5. Fix the new guide shafts to the back plate
Apply Loctite 243 threadlocker to the threaded
hole of the guide shafts.
Then temporarily fix the back plate with the
guide shafts.
Linear modules with linear ball
bearings have shaft seals fitted in the
front plate and back plate. These must
remain installed when the guide shafts
are replaced.
6. Screw the new guide shafts tightly to the
back plate
(1) Push the back plate to the stop of the guide
block.
(2) Tighten the screws firmly.
Tightening torque: 18 Nm
If the guide does not move smoothly,
loosen the screws again and repeat
this step.
ENG
NTI AG / LinMot