Table of Contents
Advertisement
Installation Guide Linear Modules
8 Spare Parts
8.1 Linear Ball Bearings
The SM01 linear modules are available with linear ball bearings or plain bearings. Both bearing types can be
exchanged. The linear ball bearings are greased at the factory with the food-grade lubricant LU02 (food-
grade: UH1 approval). The replacement interval of the bearings is determined by the function test of the
linear guide. See chapter 10.1.
8.1.1 Ordering Information
All 4 linear ball bearings with the 4 associated seals should be replaced per linear module.
For Linear Modules SM01-37
Item
Linear Ball Bearing EXC-20-F-RB
LBBR 20x28x5/19.02
For Linear Modules SM01-48
Item
Linear Ball Bearing EXC-25-F-RB
LBBR 25x35x5
8.1.2 Mounting
Always observe the safety instructions in chapter 2 during installation!
Page 26 / 85
Description
20x28x30 with misalignment compensation,
Klüber-synth UH1 14-31
Seal linear ball bearing
Description
25x35x40 with misalignment compensation,
Klübersynth UH1 14-31
Seal linear ball bearing
1. Release guide shafts
(1) Loosen the screws of the guide shafts on
the front plate.
(2) Then push the guide shafts outwards, but
do not pull them out completely.
2. Remove slider
Now the slider can be removed together with
the front plate.
SM01-37 / SM01-48
Mark the "top" and "bottom" of the
front plate so that it can be reinstalled
exactly the same.
When handling with sliders, there are
sometimes large magnetic forces of
attraction.
Observe the warnings in section 2! If
necessary, cover nearby iron
structures with non-magnetic material
(e.g. wood).
ENG
Item-No.
0160-3221
0160-3167
Item-No.
0160-3222
0160-3106
NTI AG / LinMot
Advertisement
Table of Contents
