Table of Contents
Advertisement
Installation Guide Linear Modules
Spherical washer
Page 32 / 85
9. Fix the guide shafts
Apply Loctite 243 threadlocker to the threaded
hole of the guide shaft.
Then fasten the front plate (2) temporarily with
the guide shafts (1).
10. Screw the guide shafts tightly
(1) Push the guide shafts to the stop of the
guide block.
(2) First tighten the screw on the face-turned
shaft end, then tighten the other screw.
Tightening torque: 18 Nm
11. Note the installation position of the plates
SM01-37 / SM01-48
For linear modules with plain bearings,
2 spherical washers are attached
crosswise to the end of the shafts.
If the guide does not move smoothly,
loosen the screws again and repeat
this step. Do not loosen the plain
bearing holders (4 pieces). Alignment
is done via the spherical washers,
which must be tightened according to
the instructions.
The front plate must be positioned on
the side of the connector and the rear
plate on the opposite side.
The installation positions of the
mounting plates must not be
interchanged!
ENG
NTI AG / LinMot
Advertisement
Table of Contents
