Table of Contents
Advertisement
Installation Guide Linear Modules
NTI AG / LinMot
3. Remove the guide shafts
The guide shafts are pulled out together with
the back plate.
4. Dismantle tube support
(1) Dismantle the left and right rear tube
support.
(2) Remove bearing tube.
5. Dismantle old linear ball bearings
(1) Remove the old seals by hand.
(2) Pull out the old bearings using a universal
puller such as Kukko 27-A.
6. Insert new linear ball bearings and seals
(1) The new bearings are inserted as far as
they will go with the help of a hand press or a
press pin.
(2) After that, there is approx. 5 mm space left
to insert the seals.
SM01-37 / SM01-48
Mark the "top" and "bottom" of the
back plate so that it can be reinstalled
exactly the same.
The bearings are already initially
lubricated.
ENG
Page 27 / 85
Advertisement
Table of Contents
