Table of Contents
Advertisement
Installation Guide Linear Modules
4.3.1 Installation Arrangement
The SM01 linear modules are optionally available with permanently installed MagSpring (option MSxx).
These include the strength classes from 40 N to 120 N constant force. After vertical installation of the linear
module, a constant force acts against the gravitational force to compensate for the moving load mass. For
the sizing of the MagSpring, the moving mass of the module (chapter 12) and the additional load mass
(customer-specific) must be considered.
Danger of crushing with the MagSpring force.
When loads are disassembled, the MagSpring force can pull the module into the end
position.
Never hold fingers between the end plate and the stator.
4.3.2 MagSpring Slider Attachment
Mounting plate
Sleeve
NTI AG / LinMot
SM01-37
Slider
SM01-37 / SM01-48
SM01-48 (2 x MagSpring)
When handling with sliders, there are
sometimes large magnetic forces of
attraction.
Observe warning instructions in
section 2!
In order to avoid statically constraining the
mounting of the MagSpring slider, it is non-
rigidly attached to the mounting plate. This is
ensured by the built-in sleeve.
With each assembly, make sure to
reinstall the sleeve so that the slider
can be moved sideways!
ENG
Page 11 / 85
Advertisement
Table of Contents
