Installation Guide Linear Modules
Page 30 / 85
2. Remove slider
Now the slider can be removed together with
the front plate.
3. Remove the guide shafts
The guide shafts are pulled out together with
the back plate.
4. Dismantle the old plain bearings
Pull out the old bearings using a universal
puller such as Kukko 27-A.
5. Insert new plain bearings
The new bearings are inserted as far as they
will go with the help of a hand press or a press
pin.
SM01-37 / SM01-48
Mark the "top" and "bottom" of the
front plate so that it can be reinstalled
exactly the same.
When handling with sliders, there are
sometimes large magnetic forces of
attraction.
Observe the warnings in chapter 2! If
necessary, cover nearby iron
constructions with non-magnetic
material (e.g. wood).
Mark the "top" and "bottom" of the
back plate so that it can be reinstalled
exactly the same.
ENG
NTI AG / LinMot