Table of Contents
Advertisement
Installation Guide Linear Modules
Shaft seals
Page 28 / 85
7. Insert bearing tube and mount tube support
(1) Push the bearing tubes into both tube
supports.
(2) Screw on the tube support. Apply Loctite
243 threadlocker to these screws.
Tightening torque for SM01-37:
Tightening torque for SM01-48:
8. Insert guide shafts
The guide shafts are reinserted together with
the back plate on the side without connector.
9. Insert slider
The slider is inserted together with the front
plate on the side of the connector.
10. Fix guide shafts
Apply Loctite 243 threadlocker to the threaded
hole of the guide shafts.
Then fasten the front plate (2) temporarily with
the guide shafts (1).
SM01-37 / SM01-48
When handling with sliders, there are
sometimes large magnetic forces of
attraction.
Observe the warnings in section 2! If
necessary, cover nearby iron
structures with non-magnetic material
(e.g. wood).
Make sure that the shaft seals are
inserted in the back plate.
ENG
4.2 Nm
7.4 Nm
NTI AG / LinMot
Advertisement
Table of Contents
