Table of Contents
Advertisement
Installation Guide Linear Modules
8.3.4 Guide Shafts for SM01-48 Linear Modules with Plain Bearings
Artikel
SL01-30-25x339-SSC-HIS
SL01-30-25x399-SSC-HIS
SL01-30-25x489-SSC-HIS
SL01-30-25x609-SSC-HIS
SL01-30-25x699-SSC-HIS
8.3.5 Mounting
Be sure to observe the safety instructions in chapter 2 during assembly!
NTI AG / LinMot
Beschreibung
Guide shaft, hollow, SSC, hardened, L= 339 mm for
SM01-48x150, Stroke = 105 mm
Guide shaft, hollow, SSC, hardened, L= 399 mm for
SM01-48x150, Stroke = 165 mm
SM01-48x240, Stroke = 75 mm
Guide shaft, hollow, SSC, hardened, L= 489 mm for
SM01-48x150, Stroke = 255 mm
SM01-48x240, Stroke = 165 mm
Guide shaft, hollow, SSC, hardened, L= 609 mm for
SM01-48x150, Stroke = 375 mm
SM01-48x240, Stroke = 285 mm
Guide shaft, hollow, SSC, hardened, L= 699 mm for
SM01-48x240, Stroke = 375 mm
SM01-37 / SM01-48
1. Remove guide shafts
(1) Loosen the screws of the guide shafts on
the front plate.
(2) Then pull out the guide shafts together with
the back plate.
Mark the "top" and "bottom" of the
front plate so that it can be reinstalled
exactly the same.
2. Loosen the back plate from the guide shafts
Clamp the guide unit and loosen the screws of
the guide shafts on the back plate completely.
Mark the "top" and "bottom" of the
back plate so that it can be reinstalled
exactly the same.
ENG
Art-Nr.
0150-4400
0150-4150
0150-4151
0150-4152
0150-4153
Page 35 / 85
Advertisement
Table of Contents
