Table of Contents
Advertisement
Installation Guide Linear Modules
NTI AG / LinMot
6. Place guide shafts, plates and spherical
washers in the correct position
7. Insert guide shafts
The guide shafts are reinserted together with
the back plate on the side without connector.
8. Insert slider
The slider is inserted together with the front
plate on the side of the connector.
SM01-37 / SM01-48
Before the guide shafts are inserted
and screwed tight, they and the
spherical washers as well as the front
and rear plates must be positioned
correctly. Pay attention to the diagonal
positioning of the face-turned shaft
ends. Spherical washers must also be
inserted diagonally, at the shaft ends
that are not face-turned.
When handling with sliders, there are
sometimes large magnetic forces of
attraction. Observe the warnings in
chapter 2! If necessary, cover nearby
iron constructions with non-magnetic
material (e.g. wood).
ENG
Page 31 / 85
Advertisement
Table of Contents
